Double Girder EOT Crane Manufacturer in Ahmedabad, Gujarat
Engineered for Heavy Loads. Built to Outlast the Toughest Shop-Floor Conditions.
Built for Gujarat’s Heavy Industries
If your operation runs on heavy loads, long bay spans, and round-the-clock shifts, a single girder crane simply won’t hold up; that’s where a double girder EOT crane earns its place. At MP Crane India, we’ve been designing and manufacturing double girder overhead cranes out of our Ahmedabad, Gujarat facility since 2011, and every unit that leaves our shop floor is built around one idea: no two plants work the same way, so no two cranes should either.
We don’t sell off-the-shelf. Every double girder overhead crane we manufacture in Ahmedabad is engineered to IS 807 and IS 3177 standards, then customised to your bay length, headroom, duty cycle, and load pattern. Whether you’re running a foundry in Vatva, a steel fabrication unit in Changodar, or a heavy engineering plant anywhere in Gujarat, we design the crane around your shop floor, not the other way around.
As a double girder EOT crane manufacturer based in Ahmedabad, we also supply and install across India, so wherever your facility is, the same engineering rigour and after-sales support follows.
Ahmedabad and the surrounding industrial belt, from Naroda and Odhav to Sanand and Changodar, is home to some of the country’s busiest foundries, steel plants, and heavy fabrication units. These operations don’t get downtime for crane failure, which is exactly why our double girder EOT cranes are rated for M5 to M8 duty class and engineered to run hard, shift after shift, without breaking stride.
We understand the terrain locally, because we’re based right here in Gujarat. That means faster site visits, quicker turnaround on customisation, and a support team that’s a phone call away rather than a flight away.
5 Tons to 250 Tons
Up to 30 Metres (custom available)
5 to 50 Metres
Higher hook height, heavier loads, longer spans, auxiliary hoist ready
Auxiliary Hoist & Special Attachment Ready
Need to run a grab bucket, an electromagnet, or a secondary hoist alongside your main lift? Our double girder crane design is built to accommodate auxiliary equipment right from the drawing board no bolt-on modifications, no compromise on structural integrity later.
Longer Spans, Zero Structural Compromise
Some jobs need a crane that spans the entire width of a bay of 40, even 50 metres, while still carrying loads upwards of 100 tonnes. That’s not a small ask structurally, but it’s exactly the kind of challenge our in-house design team is built for. We engineer the girder, end carriages, and runway interface to carry the load safely, without over-building or under-delivering.
Why Manufacturers Across Ahmedabad Choose MP Crane India
- Local manufacturing, local accountability — designed and fabricated at our Gandhinagar–Ahmedabad facility, so lead times and site support stay tight.
- Built to IS 807 & IS 3177 — every crane goes through design validation before it reaches your floor.
- Custom-engineered, not catalogue-picked — span, lift height, and duty class are matched to your actual operating conditions.
- Pan-India reach, Gujarat-rooted — while our base is in Ahmedabad, our cranes run in plants across the country.
- Since 2011 — over a decade of building overhead cranes for India’s toughest industrial environments.
Looking for a reliable double girder EOT crane manufacturer in Ahmedabad? Talk to our engineering team about your span, load, and duty cycle requirements; we’ll design a crane around your actual shop floor, not a standard template.